ImageEn Forum

Profile Join Active Topics Forum FAQ

All Forums

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

View

UserName:

Password:

Format

Message

Check here to include your profile signature.
Check here to subscribe to this topic.

T O P I C R E V I E W
AndyColmes	Posted - Jun 13 2014 : 16:10:02 I have 3 layers in a TImageEnVect. I would like to make a selection and then allow which layer to "show through" the selection, like a cutout hole. How would I do this efficiently? Thanks in advance. Andy
2 L A T E S T R E P L I E S (Newest First)
xequte	Posted - Jun 16 2014 : 16:15:50 Hi Andy You can use SelCutToClip to remove the selection of a layer, but at this stage it does not revert the cut section to alpha. In the next release we will had a "CutAlpha" parameter, so you can call it as follows: ImageEnView1.Proc.SelCutToClip(true, true); Nigel Xequte Software www.xequte.com nigel@xequte.com
w2m	Posted - Jun 13 2014 : 16:43:17 Unfortunately, this may not be possible. The layer that shows is the topmost layer, so just by making a selection will not achieve what you are looking for. Nigel may have an idea for this, but I suspect it is just not possible to achieve. Bill Miller Adirondack Software & Graphics Email: w2m@hughes.net EBook: http://www.imageen.com/ebook/ Custom Commercial ImageEn Development